Table of Contents
Advertisement
4
To verify IP communications between the PC and the Avidia management card, do a ping
from the PC to the IP address of the Avidia management card.
To do a ping, from a DOS prompt, type the ping command in the following format then
press
ENTER
xxx.xxx.xxx.xxx).
ping <ipaddress>
If the ping is successful, several reply messages display on the PC monitor. If the ping is
not successful, an error message displays, indicating that the request has timed out. If the
ping fails, make sure the Ethernet cable is securely connected to your PC and to the Avidia
system, and that you typed the correct IP address. Then try another ping.
5
Set the monitor screen resolution to a minimum of 800 x 600 dpi (dots per inch).
Refer to your operating system documentation for instructions on adjusting the screen
resolution.
N
S
EXT
TEPS
To use the command-line interface, go to
To use the Web interface, go to
Avidia System Configuration and Management User Manual
, where <ipaddress> is the Avidia management card IP address (format
"The Avidia Web Interface" on page
Chapter 2: Preparing for System Configuration and Management
"The Avidia Command-Line Interface" on page
77.
369.
17
Advertisement
Table of Contents
