Table of Contents
Advertisement
8
In the
Destination Retry Limit
The retry limit is the maximum number of allowable unsuccessful call setup attempts.
9
In the
Tx Idx
box, type the traffic descriptor profile index to assign to transmitted traffic.
To view the
10
In the
Rx Idx
To view the
11
Click
Set
to save the SPVC configuration, otherwise click
Deleting SPVCs
1
In the
SPVC Configuration
delete.
Click
and
table.
displays the next page of the table.
2
Click
next to the row that contains the information you want to delete.
A confirmation dialog displays.
3
Do one of the following:
•
Click
Delete
to return to the
•
Click
Cancel
C
ONFIGURING
If an Avidia system has two line cards installed, you can configure IISP (Interim Inter-Switch
Signaling Protocol) static routes to provide line card redundancy. IISP enables static routing of
signaling messages between clustered AVIDIA systems. When a line card fails, the system uses
the IISP static route configuration to reroute SPVCs to another line card.
You configure ATM Routing from the
open the
ATM Routing Table
•
In the
Site Map Navigation
•
In the
Tree Navigation
Avidia System Configuration and Management User Manual
box, type a retry limit value between 0 and 65535.
ATM Traffic Descriptor Configuration Table
box, type the traffic descriptor profile index to assign to received traffic.
ATM Traffic Descriptor Configuration Table
window, locate the table row that contains the entry you want to
if necessary to view the entire table.
to delete the selected table entry, then in the confirmation dialog click
SPVC Configuration
to return to the
SPVC Configuration
ATM R
OUTING
window:
window, click
window, click
Chapter 22: Configuring ATM Virtual Circuits
, click
, click
window.
window without deleting the table entry.
ATM Routing Table
window. Do one of the following to
Routing Table
.
Configuration Management
Browse
.
Browse
.
Cancel
.
displays the beginning of the
,
ATM, Routing Table
Back
.
457
Advertisement
Table of Contents
