Table of Contents
Advertisement
Daisy Chain Configuration
Consider what traffic contract you need to set up for each connection and what policing, through
the Usage Parameter Control (UPC), applies to the connection.The traffic contract and policing
you select is dependent on the service you provide. The traffic contract and policing selection
should maximize the network throughput and minimize end-to-end delays, thus efficiently
utilizing the network. Complete the following sections to set up the connections for subtending.
Create ATM Profiles. Create ATM profiles, if required, for the service you will supply (see
"Configuring ATM Traffic Profiles" on page 154
"Configuring ATM Traffic Profiles" on page 428
upstream and downstream rates and the QoS must be supported end-to-end.
Select a traffic type. See
Select a value for traffic parameters to complete the traffic contract. See
traffic parameters available.
Configure Service. For each card that is subtending or subtended, configure the applicable
service:
•
DS1/DSX-1: see
"Configuring DS1 Service" on page 417
•
DS3: see
"Configuring DS3 Service" on page 149
"Configuring DS3 Service" on page 422
•
OC3 service: see
"Configuring OC3 Service" on page 416
Avidia System Configuration and Management User Manual
page 20
for a list of available traffic types.
"Configuring DS1 Service" on page 143
"Configuring OC3 Service" on page 142
Chapter 3: Applications and Configuration Overview
for the command-line interface or
for the Web interface). Remember that
(command-line interface) or
(Web interface)
(command-line interface) or
(Web interface)
(command-line interface) or
(Web interface)
page 21
for a list of
55
Advertisement
Table of Contents
