Automatic Protection Switching - ADC AVIDIA SWD4573I1 User Manual

System configuration and management
Table of Contents

Advertisement

Managing Traffic for Redundancy
You can configure the Avidia system for static load sharing, using two installed line cards.
However, if one line card fails, the second line card takes over the functionality of the failed line
card, and re-establishes all the connections. This can result in too heavy a traffic load on the
second line card. To handle this, you can configure the recovery priority by traffic type (for
example, CBR first, rt-VBR second). If you do not configure recovery priorities, the
connections are recovered sequentially until no further resources are available. After that point,
the remaining connections are dropped. See
information about static load sharing and traffic management.
When an initial call request is unsuccessful, or an existing connection fails, and the call has been
retried the maximum configured number of times, the call request is re-routed using the other
line card.

Automatic Protection Switching

OC3 line cards have two physical SONET interfaces, each with a transmit and receive port.
Under normal operation, all traffic is carried through the first interface; the second is not used.
Automatic Protection Switching (APS) uses the second interface to provide a backup to the first.
Avidia uses 1+1 unidirectional APS. In this version of APS, the primary interface is defined as
the working channel. The second interface is defined as the protection channel. Transmitted data
is sent over both channels. Data is normally received through the working channel. However, if
the working channel fails, received data automatically switches to the protection channel.
By default, APS is disabled on Avidia systems. You must enable APS for automatic switching
to occur. See
"Configuring APS" on page 158
on page 430
(Web interface) to enable APS.
Avidia System Configuration and Management User Manual
Chapter 3: Applications and Configuration Overview
"Static Load Sharing" on page 30
(command-line interface) or
for more
"Configuring APS"
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avidia switchware version 2.0

Table of Contents

Save PDF