2
Select the slot you want to configure, then click
Configuring APS
1
In the
Admin Status
The default is disabled.
2
In the
Trap
box, select
3
In the
Mode
box, select the desired APS mode:
•
Non Revertive Manual—
automatically switch back to the working channel when the failure on that channel has
been cleared (this is the default).
•
Non Revertive Auto—
automatically switch back to the working channel when the system detects an error on
the protection channel and the failure on the working channel has been cleared.
•
Revertive—
switch back to the working channel when the failure on the working channel has been
cleared for a user-specified amount of time.
Avidia System Configuration and Management User Manual
box, select
Enabled
Enabled
or
Disabled
once traffic has switched to the protection channel it will not
once traffic has switched to the protection channel it will
once traffic has switched to the protection channel, it will automatically
Chapter 22: Configuring ATM Virtual Circuits
OK
to display the
or
to enable or disable APS.
Disabled
to enable or disable APS trap generation.
APS Configuration
window.
431