Table of Contents
Advertisement
Configuring IP Routing
Adding IP Routing Table Entries
From the ::routingtb=> prompt type the new command in the following format, then press
ENTER
.
new <destip> <nexthop> [-hopcount <hopcount>]
Parameters
<destip>
The IP address to which packets must be sent to qualify for routing based on this IP Routing
Table entry.
<nexthop>
The IP address of the next router in the network to which the packet is to be forwarded.
[-hopcount <hopcount>]
The number of hops the packet is allowed to make to get to its destination. If the packet
makes the maximum number of hops allowed by the RIP configuration (see
RIP Configuration" on page
Example
::routingtb=> new 100.90.57.3 100.90.57.4 -hopcount 10
Displaying the IP Routing Table
To verify your IP routing configuration, from the ::routingtb=> prompt, type the show
command as follows then press
show [<ipaddr>]
Parameter
[<ipaddr>]
The IP address of the IP Routing Table entry you want to display (format xxx.xxx.xxx.xxx).
Omitting this parameter displays all IP Routing Table entries.
236
242), and is not yet at its destination, it is deleted.
ENTER
.
Avidia System Configuration and Management User Manual
"Modifying
Advertisement
Table of Contents
