Initiating Communication Path Loopbacks - ADC AVIDIA SWD4573I1 User Manual

Deleting OAM Loopbacks
1 Locate the table row that contains the
Click and
table. displays the next page of the table.
2 Click next to the row that contains the information you want to delete.
A confirmation dialog displays.
3 Do one of the following:
• Click
Delete
to return to the
•
Click Cancel
entry.
I C
NITIATING
The Avidia system supports loopbacks that enable you to test the data communication path
between a card in the Avidia system and another device with the same transmission. You can
run these loopbacks on DS1/DSX-1, DS3, and OC3 lines. Definitions of end-points for these
tests include the near-end which is the local Avidia card and the far-end which is the device (this
could be another Avidia card) that is the remote end for the test.
When you initiate a loopback test on a data communication path, normal service is
interrupted for that path until the test is cancelled. The system is then returned to normal
operation.
Avidia System Configuration and Management User Manual
if necessary to view the entire table.
to delete the selected table entry, then in the confirmation dialog click
OAM Loopback Table
to return to the OAM Loopback Table
OMMUNICATION
Chapter 29: System Maintenance and Administration
OAM Loopback Table entry you want to delete.
window.
window without deleting the table
P L
ATH OOPBACKS
displays the beginning of the
Back
563