Table of Contents
Advertisement
Configuring APS
4
If you selected
that you want the system to wait before switching traffic from the protection channel back
to the working channel after a failure on the main channel has been cleared. Otherwise, skip
this step.
The range is 300 to 720 seconds. The default is 300 seconds.
5
Do one of the following:
•
To activate the settings and close the
confirmation dialog click
•
Click
Get
not clicked
Issuing Manual APS Commands
Once APS is enabled, if the APS is currently set to either Non Revertive mode, you can override
the configured APS operation by selecting one of the following APS commands. After issuing
a manual APS command, you must issue a
operation.
1
In the
Switch Command
•
Clear—
clears any of the following manual commands.
•
Lockout Protection—
•
Force to Protection—
•
Force to Working—
•
To Working If Ready—
conditions (such as the configured Wait To Revert Time or a failure condition) that
prohibit switching to that channel.
2
Do one of the following:
•
To activate the settings and close the
confirmation dialog click
•
Click
Get
not clicked
432
Revertive
in
Step
3, in the
Back
.
to cancel the new settings. You can only cancel the new settings if you have
Set
.
box, select the desired manual APS command.
disables APS.
switches traffic to the protection channel.
switches traffic to the working channel.
switches traffic to the working channel if there are not other
.
Back
to cancel the new settings. You can only cancel the new settings if you have
Set
.
Wait Time To Revert
box type the number of seconds
APS Configuration
window, click
Clear
command to resume the configured APS
window, click
APS Configuration
Avidia System Configuration and Management User Manual
Set,
then in the
then in the
Set,
Advertisement
Table of Contents
