Table of Contents
Advertisement
Configuring IDSL Alarm Profiles
Parameter
<index>
The index number of the IDSL line profile you want to delete.
Example
::line=> delete 2
C
ONFIGURING
IDSL alarm profiles determine the conditions that generate SNMP traps. When the configured
thresholds are met or exceeded, the SNMP agent sends a trap to the configured trap receiver(s).
IDSL port configuration requires you to apply an IDSL alarm profile to the line, therefore you
must configure the desired IDSL alarm profile before configuring an IDSL port. A default
profile exists with an index of 1. You cannot delete the default profile.
You configure IDSL alarm profiles from the ::alarm=> prompt. From the ::root=>
prompt, type the following command then press
configuration idsl profile alarm
Adding IDSL Alarm Profiles
From the ::alarm=> prompt, type the new command in the following format then press
ENTER
to create a new IDSL alarm profile.
new <hourly ES> <hourly SES> <daily ES> <daily SES>
Parameters
<hourly ES>
The hourly ES threshold is the number of errored seconds that must be met or exceeded on
the IDSL line within an hour for a trap to occur. The range is 0 (disable) to 255, with 40 as
the default.
An errored second generates when one or more block errors (CRC violations) are detected
during a one second interval.
130
IDSL A
LARM
P
ROFILES
ENTER
to display the ::alarm=> prompt.
Avidia System Configuration and Management User Manual
Advertisement
Table of Contents
