Table of Contents
Advertisement
Configuring Cell Channel Card PVCCs
You can configure cross-connect PVCCs between cell-based channel cards and either line cards
or the management card. You configure PVCCs from the ::pvcc=> prompt. From the
::root=> prompt, type the following command then press
prompt.
configuration atm cell pvcc
Adding Cell Channel Card PVCCs
From the ::pvcc=> prompt, do one of the following:
•
To add one PVCC, type the new command in the following format then press
PVCC table index number is automatically assigned.
new <src port> <vpi> <vci> <dst port> <vpi> <vci>
[-admin (up|down)][-txtraf <src index>] [-rxtraf <src index>]
[-backup [<lport> <vpi> <vci>]]
•
To add multiple PVCCs with the same traffic profile, type the range command in the
following format then press
range <#pvcs> <src port> <vpi> <vci> <dst port> <vpi> <vci>
[-admin (up|down)][-txtraf <src index>] [-rxtraf <src index>]
[-y]
Parameters
<#pvcs>
The number of PVCCs you want to create with the same traffic profile. See the table on
page 24
to verify that the ports you plan to use for the PVCCs support the number of
PVCCs you intend to create.
<src port>
One of the PVCC ports (format slot.port). This can be either the line card or the channel
card port.
<lport>
The other PVCC port (format slot.port). This can be either the line card or the channel card
port.
<vpi>
The VPI associated with the preceding <port> parameter in the command line. See the
table on
page 24
Avidia System Configuration and Management User Manual
ENTER
.
for a summary of the supported VPI ranges for each card.
Chapter 8: Configuring ATM Virtual Circuits
ENTER
to display the ::pvcc=>
ENTER
. The
171
Advertisement
Table of Contents
