Table of Contents
Advertisement
Configuring DS1 Service
The
DS1 Configuration
changed.
Information
Card Description
Slot
Port
Oper Status
Elapsed Time
Valid Intervals
Invalid Intervals
Line Status
Last Line Status Change
Send Code
Facilities Data Link
Loopback Status
420
window displays the following status information that cannot be
Descriptions
The slot number, port number and description of the selected
card.
The current operational status of the selected port.
• Up indicates the port is operational and passing data.
• Down indicates that the port is not operational.
The number of seconds that have elapsed since the current
15-minute data collection period began.
The number of 15-minute data collection intervals supported.
The Avidia system supports 96 intervals, or 24 hours, of data
collection.
The Avidia system does not have invalid intervals, therefore
displays.
The status of the line interface. Options:
• dsx1NoAlarm—No alarm is present.
• dsx1RcvFarEndLOF—Remote loss of frame alarm.
• dsx1RcvAIS—Remote AIS.
• dsx1LossOfFrame—Local loss of frame alarm.
• dsx1LossOfSignal—Local loss of signal alarm.
The time at which the line entered its current status (see the
Line Status description above for a definition of line status).
The type of data currently being transmitted. Currently, the only
data type supported is sending Looped or normal data.
This parameter is not currently supported, therefore
dsx1FdlNone displays. Facilities Data Link is a protocol that
enables communication with the remote device when in ESF
mode.
The type of physical layer loopback in effect. See
Communication Path Loopbacks" on page 563
about loopbacks.
Avidia System Configuration and Management User Manual
0
"Initiating
for information
Advertisement
Table of Contents
