Modifying RIP Configuration
Example
::arptb=> delete 2
M
ODIFYING
The RIP Configuration Table displays information about the Routing Information Protocol
(RIP) used for each routing session. You configure RIP information initially during session
configuration, however you can modify it using the following procedures.
You modify RIP information from the ::rip=> prompt. From the ::root=> prompt, type
the following command then press
configuration routing rip
Modifying RIP
1
From the ::rip=> prompt, type show then press
for each session.
2
Note the index number of the RIP Configuration Table entry you want to modify.
3
Type the modify command in the following format, then press
modify <index> [-send(ripv1c|ripv1|ripv2|donotsend)]
[-recv(ripv1|ripv2|v1orv2|donotrecv)] [-key <plain text
password>] [-auth none]
Parameters
<index>
The RIP Configuration Table index number of the entry you want to modify.
[-send(ripv1c|ripv1|ripv2|donotsend)]
•
ripv1c
—
with RIP 1)
•
ripv1
—
send RIP Version 1 packets only
•
ripv2
—
RIP Version 2 packets only
•
donotsend
242
RIP C
ONFIGURATION
ENTER
send RIP Version 1c packets only (RIP 2-type packets that are compatible
—
no RIP packets are sent
to display the ::rip=> prompt.
ENTER
to display the RIP configuration
Avidia System Configuration and Management User Manual
ENTER
.