Table of Contents
Advertisement
Configuring Frame Channel Card PVCCs
You can configure cross-connect PVCCs between frame-based channel cards and line cards or
the management card. You configure PVCCs from the ::pvcc=> prompt. From the
::root=> prompt, type the following command then press
prompt.
configuration atm frame pvc
Adding Frame Channel Card PVCCs
For frame channel cards, the VPI is always zero and the system automatically
assigns the VCI. Therefore, you do not enter this information during frame
channel card PVCC configuration.
From the ::pvcc=> prompt, do one of the following:
•
To add one PVCC, type the new command in the following format then press
PVCC table index number is automatically assigned.
new <cport> <lport> <lvpi> <lvci> [-mode (vcmux|llc)]
[-admin (up|down)][-txtraf <index>] [-rxtraf <index>]
[-backup [<lport> <vpi> <vci>]]
•
To add multiple PVCCs with the same traffic profile, type the range command in the
following format then press
range <#pvcs> <cport> <lslot> <lvpi> <lvci>
[-mode (vcmux|llc)] [-admin (up|down)] [txtraf <index>]
[-rxtraf <index>] [-y]
Parameters
<#pvcs>
The number of PVCCs you want to create with the same traffic profile. See the table on
page 24
to verify that the ports you plan to use for the PVCCs support the number of
PVCCs you intend to create.
<cport>
The channel card slot number or slot and port number for the PVCC. To map the PVCC to
a specific service type on a specific port, specify slot.port. Otherwise, use the format slot.
Avidia System Configuration and Management User Manual
ENTER
.
Chapter 8: Configuring ATM Virtual Circuits
ENTER
to display the ::pvcc=>
ENTER
. The
179
Advertisement
Table of Contents
