Table of Contents
Advertisement
The following table describes the information displayed after you type the atm show command:
Information
Slot
MaxPVPCs
MaxPVCCs
PVPCs
PVCCs
MaxVPIBits
MaxVCIBits
Configuring Cell Channel Card PVPCs
You can configure cross-connect PVPCs between ATM ports on cell-based channel cards and
ATM ports on line cards. You configure PVPCs from the ::pvpc=> prompt. From the
::root=> prompt, type the following command then press
prompt.
configuration atm cell pvpc
Avidia System Configuration and Management User Manual
Chapter 8: Configuring ATM Virtual Circuits
Description
The slot number of the ATM port for which the
information is displayed.
The maximum number of PVPCs that can be
configured on the selected port.
The maximum number of PVCCs that can be
configured on the selected port.
The current number of PVPCs configured on the
selected port.
The current number of PVCCs configured on the
selected port.
The number of VPI bits in each cell header that
are used by the Avidia system.
The number of VCI bits in each cell header that
are used by the Avidia system.
ENTER
to display the ::pvpc=>
163
Advertisement
Table of Contents
