Table of Contents
Advertisement
Modifying Frame Relay FRF.8 Circuit Parameters
You can modify a subset of the parameters that you configured when creating the frame relay
circuit.
1
From the ::frf8=> prompt, type show then press
circuits.
2
Note the index number of the frame relay FRF.8 circuit configuration you want to modify.
3
From the ::frf8=> prompt, type the set command in the following format then press
ENTER
.
set <index> [-admin (up|down)] [-lpmode (1|2)]
[-lpvalue (0|1)] [-cimode (1|2)] [-demode (1|2)]
[-devalue (0|1)] [-CIR <value>] [-Be <value>] [-Bc <value>]
Parameters
<index>
The index number of the frame relay FRF.8 circuit you want to modify.
[-admin (up|down)]
The administrative status of the line. up activates the port, down deactivates the port.
[-lpmode (1|2)]
The LP mode determines the content of the ATM CLP field when translating from frame
relay to ATM.
1—The frame relay header DE field is mapped into the ATM CLP field of every ATM cell
generated by the segmentation process of the AAL5 PDU containing the information for
that frame.
2—The ATM CLP field of every ATM cell generated by the segmentation process of the
AAL5 PDU containing the information of that frame is set to the LP value.
[-lpvalue (0|1)]
The LP Value determines the content of the ATM cell CLP field when the LP mode is set
to 2.
0—The network cannot discard cells.
1—The network can discard cells.
Avidia System Configuration and Management User Manual
Chapter 9: Configuring Frame Relay Interworking
ENTER
to display the configured
215
Advertisement
Table of Contents
