Table of Contents
Advertisement
Chapter 5 Configuring the Interfaces Using the Console Interface
Configuring the ATM PNNI 1.0 Interface
Configuring PNNI ILMI
Commands
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
5-14
choose a number divisible by 5040, such as 10080, 15120, and so on. If you
want to use a value smaller than 5040, choose a multiple of 5040, such as 2,
3, 5, 6, 7, 8, 9, 10, and so on, or their multiples.
5 To apply the interface configuration values, select the Apply Interface
Configuration command and press Enter.
6 To activate the interface after you have applied the configuration values,
select the Bring Interface Into Service command and press Enter.
End
Perform these steps to configure your connection for PNNI integrated link
management interface (ILMI):
Steps to Configure the PNNI ILMI Interface
Begin
1 From the ATM PNNI Interface Configuration window, select the ILMI
Configuration command, or press Ctrl+O.
The PNNI ILMI Configuration window is displayed (see Figure 5-3).
Figure 5-3.
PNNI ILMI Configuration Window
The commands on this window have the following functions:
Release 7.0
255-700-184
Advertisement
Table of Contents
