Adding Circuit Emulation-To-Circuit Emulation Pvc Connections; Creating A Circuit Emulation-To-Circuit Emulation Vcc Connection - Lucent Technologies PacketStar PSAX Series User Manual

1-port channelized sts-1e, t1 format module
Hide thumbs Also See for PacketStar PSAX Series:
Table of Contents

Advertisement

Chapter 8 Provisioning Connections Using the AQueView
Creating ATM-to-ATM VPC PVC Connections

Adding Circuit Emulation-to-Circuit Emulation PVC Connections

Creating a Circuit
Emulation-to-Circuit
Emulation VCC
Connection
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
8-70
The Out B or Decoded B column displays cells or bits transmitted from side A
to side B (also displayed on the Statistics page in the Cells Transmitted field
on the Interface B Statistics panel).
7 Select a time interval from the pull-down menu.
8 Average bits per second is displayed by default. If you want to display
utilization by average cells per second, click Average Cells/Sec.
9 Click Poll+ and the polling begins. Click Poll- to terminate polling.
10 To refresh this window, click Clear.
11 To close the Display Connection window, click Close.
12 To save this connection to the PSAX configuration database, in the
Provisioning Menu Bar, click Device > Save PSAX Configuration.
!
CAUTION:
Click Device > Save PSAX Configuration to permanently save the
configuration.
Applied, but unsaved configuration data will not be lost unless the PSAX
system is restarted, or if power to the PSAX system is lost. Terminating the
AQueView EMS will not cause the applied values to be lost because the
configuration data is stored on the PSAX system, not in the AQueView EMS.
End
This is a fixed-rate connection and has no service types. To enable coding
translation and echo cancellation, at least one DSP2A, DSP2B, or DSP2C
Voice Server module must be present and configured.
You can process voice traffic using circuit emulation connections through
one DSP2A, DSP2B, or DSP2C Voice Server module by selecting one of the
pulse code modulation (PCM) types in the Coding Translation field.
Perform the steps in the following procedure to create a circuit-emulation-to-
circuit emulation connection.
Creating a Circuit Emulation-to-Circuit Emulation VCC PVC
Connection
Begin
1 Click the Connections tab.
The Listing page appears.
2 Click the right mouse button and a menu appears. Click Create New.
The Create Connection window appears (see Figure 8-40).
®
System
Release 7.0
255-700-184

Advertisement

Table of Contents
loading

Table of Contents