Table of Contents
Advertisement
Configuring Digital
Signal Processing
(DSP2) Parameters
Commands
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 7 Provisioning Connections Using the Console Interface
Adding a Circuit Emulation-to-Circuit Emulation PVC Connection
modules: Channelized DS3 (multifunction), 1-port Channelized
DS3 CES, 3-port Channelized DS3 CES (Release 7.0 CPU software
required), Channelized STS-1e CES, Channelized STS-1e T1,
Enhanced DS1, Enhanced E1, High-Density E1 (21 port), and
Medium Density DS1 (12-port). Save your SVCs before upgrading
your CPU software, or you will have to re-enter their
configurations.
4 To add (apply) the connection configuration, select the Add This
Connection command and press Enter.
End
Configuring DSP2 Parameters on the Circuit Emulation-to-ATM VCC
SPVC Connection
Begin
1 From the Circuit Emulation-to-ATM VCC SPVC Connection window,
select the Configure DSP2 Parameters command and press Enter (or
press Ctrl+C).
The Circuit Emulation-to-ATM VCC SPVC DSP2 Parameters window is
displayed.
Figure 7-46. Circuit Emulation-to-ATM VCC SPVC DSP2 Parameters Window
The commands on this window have the following functions:
Release 7.0
7-111
Advertisement
Table of Contents
