Adding Soft Permanent Virtual Connections; Adding Atm-To-Atm Vcc Spvc Connections; Creating An Atm-To-Atm Connection - Lucent Technologies PacketStar PSAX Series User Manual

Adding Soft Permanent Virtual Connections

Adding ATM-to-ATM VCC SPVC Connections

Creating an ATM-to-
ATM Connection
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 8 Provisioning Connections Using the AQueView
Figure 8-86. Delete Confirmation Window (Using the Delete Button)
3 Click Yes.
The entry is removed from the routing table.
4 On the VBR IISP Routing Entry window or CBR IISP Routing Entry
window, click Close.
5 In the Provisioning Menu Bar, click Device > Save PSAX
Configuration. (See the section, "Saving Configuration Values.")
End
For information on enabling and viewing ATM-to-ATM SVC connections, see
the appropriate PacketStar
Perform the steps in the following procedure to create an ATM-to-ATM VCC
SPVC connection.
Steps to Create an ATM-to-ATM VCC SPVC Connection
Begin
1 Click the Connections tab.
The Listing page appears.
2 Click the right mouse button and a menu appears. Click Create New.
The Create Connection window appears (see Figure 8-87).
Adding Soft Permanent Virtual Connections
®
Module User Guide.
®
System
Release 7.0
8-159