Adding Nsap Addresses - Lucent Technologies PacketStar PSAX Series User Manual

Table 6-3. Field Descriptions for the ATM UNI Interface Configuration Window
Field Name
Traffic Shaping
Addr Org Scope
Local NSAP Address
(Hex)
Adding NSAP
Addresses
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 6 Configuring the Interfaces Using the AQueView
Values
Default:
Disabled
Enabled
Global (default)
Intra
Organization
Organization
PlusOne
Community
PlusOne
Regional
InterRegional
2 If you want to enable support for virtual interfaces, select Enabled in the
VI Support field.
The Virtual Interface Table button becomes active.
Note:
Step 2 through Step 4 are optional. If you do not want to add or
retrieve an NSAP address, skip to Step 5.
If an NSAP address exists in the NSAP address database for a given device,
the local NSAP address automatically retrieved and displayed on the Interface
Configuration window. You may choose to add an NSAP address for a slot,
port, and channel in the NSAP address database and retrieve it by clicking
Retrieve from NSAP database.
3 To add or retrieve an NSAP address, enter a valid NSAP address in the
Local NSAP Address (Hex) field and click Retrieve from NSAP
database.
Configuring the ATM UNI and ILMI Interfaces
Description
An input cell selection algorithm
(leaky bucket) that smooths bursts of
input traffic. Available on these mod-
ules:
STM-1 Multimode and Single-Mode,
OC-3c Multimode and Single-Mode.
Disables the feature.
Enables the feature.
Note:
This feature must be enabled if
using rate shaping prior to egress from
an ATM trunk port on the OC-3c APS
or the STM-1 MSP modules.
ATM user address organizational scope.
The ATM NSAP address of the local
end of the connection, in hexidecimal
notation. Enter the NSAP address of
the local ATM interface (optional).
®
System
Release 7.0
6-21