Table of Contents
Advertisement
Deleting an Interface
Configuring the HDLC Passthrough Interface
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 5 Configuring the Interfaces Using the Console Interface
Note:
To change any other fields on the Frame Relay Interface
Configuration window, you must first delete the interface. To
delete an interface, follow the instructions in "Deleting an
Interface" below.
To change field values, perform the steps the following procedure.
Changing Field Values
Begin
1 To take an interface out of service, on the Frame Relay Interface
Configuration window (see Figure 5-13), select the Take Interface
Out Of Service command and press Enter.
2 Change the values in the fields as needed (see Table 5-12).
3 Select the Apply Interface Configuration command and press Enter.
4 To bring the interface back into service, select the Bring Interface Into
Service command and press Enter.
End
To delete an interface, perform the steps in the following procedure.
Deleting an Interface
Begin
1 To take an interface out of service, on the Frame Relay Interface
Configuration window (see Figure 5-13), select the Take Interface
Out Of Service command and press Enter.
2 Select the Delete Interface and Return command and press Enter.
The system redisplays the port and channel configuration window for
the module you are configuring.
End
Perform the following steps to set the values for the HDLC Passthrough
interface.
Configuring the HDLC Passthrough Interface
• N391
• N392
• NT3
Release 7.0
5-51
Advertisement
Table of Contents
