Table of Contents
Advertisement
Chapter 8 Provisioning Connections Using the AQueView
Managing Connections
Connection Types by
Interface Type
Managing Connections
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
8-2
Data flows in two directions between the two connection points
(interface side A and interface side B).
•
Simplex
Data flows in only one direction, from side A to side B, or from side B to
side A.
• Point-to-multipoint (not supported for the Channelized DS3 module)
Data flows in only one direction, from one point on side A to several
points on side B, or from one point on side B to several points on side A.
Before you can provision connections, you must select an interface type
value other than Unconfigured in the Interface Type field on the
Channelized DS3 Port and Channel Configuration window.
For a matrix of connection types by interface types, see the "Connection
Types by Interface Types Table" in the Reference Table appendix of this user
guide.
Within the Connections tab are four tabs that open the following pages:
•
By default, the Listing page appears when you click the Connections tab
(see Figure 8-1). The Listing page displays all existing connections
established on the device by default, that you can filter (see "Filtering
Connections in the List" on page 8-9). Connections can be created from
this window by clicking the right mouse button to display the
connections menu. The number in parentheses on the tab is the number
of connections in the list.
•
The Filter page enables you to sort and view connection types listed on
the Listing page by connection type, slot, port, and channel (see
"Filtering Connections in the List" on page 8-9)
•
The SPVC NSAP Address page enables you to enter new SPVC NSAP
addresses and to view a list of existing SPVC NSAP addresses (see "SPVC
NSAP Addresses" on page 8-12)
•
The AAL2 Trunk page allows you to add AAL2 trunk entries (see "AAL2
Trunk Configuration" on page 8-13)
®
System
Release 7.0
255-700-184
Advertisement
Table of Contents
