Table of Contents
Advertisement
Filtering Connections in the List
Filtering the Listing Page by Connection Type
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 8 Provisioning Connections Using the AQueView
3 Select the range of channels which you wish the connection
configuration to be copied in the Slot, Port, and Channel fields
4 Enter values in the VPI, VCI, DLCI, Remote VPI, Remote VCI fields as
necessary. Valid ranges are 0–4095 for VPI and Remote VPI, 0-65535 for
VCI and Remote VCI, and 16–1007 for DLCI.
Note:
The VPI and VCI fields appear for ATM interface types. The DLCI
fields appear for the frame relay interface types, and the Remote
VPI and Remote VCI fields appear for the SPVC connection types.
5 Click Copy.
The connection configuration is copied to the range of channels you
selected.
End
You can determine which connection types appear in the Listing page of the
Connections tab (see Figure 8-1). This is accomplished by making selections
in the Filter By Connection Type and Filter By Interface panels in the Filter
page of the Connections tab (see Figure 8-8).
This section describes how to filter the Listing page in the Connections tab
by choosing the types of connections that should be displayed.
Perform the steps in the following procedure to filter the Listing page by the
types of connections you select in the Filter page.
Filtering the Listing Page by Connection Type
Begin
1 In the Provisioning window, click the Connections tab.
The Listing page appears (see Figure 8-1).
2 Click the Filter tab and the Filter page appears (see Figure 8-8).
®
System
Filtering Connections in the List
Release 7.0
8-9
Advertisement
Table of Contents
