Table of Contents
Advertisement
Copying an Interface Configuration
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 6 Configuring the Interfaces Using the AQueView
The Local NSAP Address (Hex) field becomes populated in the window.
Note:
If the desired remote device does not appear in the Remote Switch
IP pull-down menu, do the following:
a. Highlight the Remote Switch IP field and enter the IP address that
corresponds to the PSAX device you want to include.
b. Type the desired values into the Slot, Port, and Channel fields and
c. Click Add.
®
The AQueView
system adds this information to the database file.
Note:
If you want to include a new entry for an existing device already
in the database, select the device from the pull-down menu in the
Remote Switch IP field, and type the desired values into the Slot,
Port, and Channel fields and click Add. The AQueView
adds this entry to the database file.
Note:
If you add database entries through the AQueView
these database changes to the text editor file by using the main
AQueView Menu Bar. Click View > NSAP Database > Save.
6 To apply the interface configuration values, click Apply.
7 If you want to use the ILMI protocol, you must select Enabled in the
ATM Signaling field. ILMI is not required if ATM signaling is disabled.
8 For more information about using the NSAP database, see the section,
"Using the NSAP Address Database" in Chapter 8 of the appropriate
®
AQueView
Element Management System User Guide.
End
The Copy button on each Interface Configuration window enables you to
copy an interface configuration to a range of channels. To copy an interface
configuration to a range of channels, perform the steps in the following
procedure from the appropriate Interface Configuration window.
Copying an Interface Configuration to Multiple Channels
Begin
1 In the Interface Configuration window, click Copy.
The Copy Interface Configuration window appears with the slot, port,
and channel of the interface you selected in the Start At: and Stop At:
panels (see figure below).
Configuring the ATM UNI and ILMI Interfaces
®
system, save
®
System
®
system
Release 7.0
6-23
Advertisement
Table of Contents
