Table of Contents
Advertisement
Chapter 6 Configuring the Interfaces Using the AQueView
Configuring the ATM Interim Interswitch Signaling Protocol (IISP) Interface
Copying an Interface Configuration
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
6-8
a. Highlight the Remote Switch IP field and enter the IP address that
corresponds to the PSAX device you want to include.
b. Type the desired values into the Slot, Port, and Channel fields and
c. Click Add.
®
The AQueView
system adds this information to the database file.
Note:
If you want to include a new entry for an existing device already
in the database, select the device from the pull-down menu in the
Remote Switch IP field, and type the desired values into the Slot,
Port, and Channel fields and click Add. The AQueView
adds this entry to the database file.
Note:
If you add database entries through the AQueView
these database changes to the text editor file by using the main
AQueView Menu Bar. Click View > NSAP Database > Save.
5 To apply the interface configuration values, click Apply.
6 To activate the interface after you have applied the configuration values,
click Bring Into Service.
Note:
The interface must have in-service status so that the PVCs and
SVCs you will set up to use this interface will work.
End
The Copy button on each Interface Configuration window enables you to
copy an interface configuration to a range of channels. To copy an interface
configuration to a range of channels, perform the steps in the following
procedure from the appropriate Interface Configuration window.
Copying an Interface Configuration to Multiple Channels
Begin
1 In the Interface Configuration window, click Copy.
The Copy Interface Configuration window appears with the slot, port,
and channel of the interface you selected in the Start At: and Stop At:
panels (see figure below).
®
System
®
system, save
®
system
Release 7.0
255-700-184
Advertisement
Table of Contents
