Table of Contents
Advertisement
Configuring the Dynamic Bandwith Circuit Emulation
Service Interface
Commands
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 5 Configuring the Interfaces Using the Console Interface
Configuring the Dynamic Bandwith Circuit Emulation Service Interface
The value InService is displayed in the [Operational Status] field.
End
This section provides instructions for configuring an I/O module for the
Dynamic Bandwith Circuit Emulation Service interface. You may configure
the following modules for the Dynamic Bandwith Circuit Emulation Service
interface:
•
Channelized DS3 module
•
Channelized STS-1e (T1) module
•
Enhanced DS1 module
If you selected the value DBCirEm (dynamic bandwidth circuit emulation
service) as the interface type, the Dynamic Bandwidth Circuit Emulation
Interface window (see Figure 5-12) is displayed.
Figure 5-12. Dynamic Bandwidth Circuit Emulation Interface Window
The commands in this window have the following functions:
Release 7.0
5-37
Advertisement
Table of Contents
