Table of Contents
Advertisement
Chapter 6 Configuring the Interfaces Using the AQueView
The HDLC Passthrough Interface
Copying an Interface Configuration
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
6-56
You can populate the Slot, Port, Channel, and NSAP Address fields for
an existing device, or add a new entry, and click Add.
4 To display the NSAP addresses previously configured for a PSAX device,
either select a remote device from the pull-down menu, or type the IP
address of the remote device in the Remote Switch IP field.
The list of NSAP addresses previously configured for that PSAX device is
displayed in the table.
5 Select the desired entry (slot, port, channel, and NSAP address) and click
Retrieve.
The Local NSAP Address (Hex) field becomes populated in the window.
Note:
If the desired remote device does not appear in the Remote Switch
IP pull-down menu, do the following:
a. Highlight the Remote Switch IP field and enter the IP address that
corresponds to the PSAX device you want to include.
b. Type the desired values into the Slot, Port, and Channel fields and
c. Click Add.
®
The AQueView
system adds this information to the database file.
Note:
If you want to include a new entry for an existing device already
in the database, select the device from the pull-down menu in the
Remote Switch IP field, and type the desired values into the Slot,
Port, and Channel fields and click Add. The AQueView
adds this entry to the database file.
Note:
If you add database entries through the AQueView
these database changes to the text editor file by using the main
AQueView Menu Bar. Click View > NSAP Database > Save.
6 To apply the interface configuration values, click Apply.
7 To bring the interface to in-service status, click Bring Into Service.
The value InService appears in the Administrative Status field.
End
The Copy button on each Interface Configuration window enables you to
copy an interface configuration to a range of channels. To copy an interface
configuration to a range of channels, perform the steps in the following
procedure from the appropriate Interface Configuration window.
Copying an Interface Configuration to Multiple Channels
Begin
1 In the Interface Configuration window, click Copy.
®
System
®
system, save
®
system
Release 7.0
255-700-184
Advertisement
Table of Contents
