Table of Contents
Advertisement
Viewing ILMI
Statistics
Field Descriptions
Table 6-6. Field Descriptions for the ILMI Statistics Page
Field Name
Link Resets
(display only)
Attachment Point Changed
(display only)
Attachment Point Verified
(display only)
Secure Link Proc Initiated
(display only)
ILMI Timeouts
(display only)
Packet Discarded
(display only)
Cold Starts Transmitted
(display only)
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 6 Configuring the Interfaces Using the AQueView
Figure 6-13. Registered User Address Table
The NSAP Address (Hex) column displays the user's registered
addresses. The Org Scope column displays the scope of the registered
addresses. If the scope is not set by the user, it will default to global (a
value of 15).
2 To go back to the ATM UNI Interface Configuration window, click Close.
End
You can view ILMI statistics on the ILMI Statistics panel of the ILMI
Configuration page (see Figure 6-12).
Descriptions of the ILMI statistics data fields are given in Table 6-15.
Number of times connectivity went down and then up again.
Number of times attachment point change was detected.
Number of times attachment point was verified successfully.
Number of times the secure link procedure was initiated.
Number of times the Get Request of any type was timed out.
Number of times a packet (pdu) was discarded due to format
error.
Number of times a Cold Start trap message was transmitted.
Configuring the ATM UNI and ILMI Interfaces
Description
®
System
Release 7.0
6-33
Advertisement
Table of Contents
