Primary Page - Lucent Technologies PacketStar PSAX Series User Manual

Table 8-6. Field Descriptions for the ATM-to-ATM VPC PVC Connection Window
Field Names
OAM Status Default: Unsupp OAM is not in use.
End-Pt
Seg-Pt
End-Seg-Pt
Intermediate-Pt The PSAX system is used as a network node and an inter-
Intra-Segment-
Pt
Connection Sta- Inactive,
tus Active
(display only)

Primary Page

®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 8 Provisioning Connections Using the AQueView
Values
The PSAX system is used as a termination point for ATM,
and will process AIS/RDI cells.
Note: The OAM loopback test is supported for end-to-
end connections only.
The PSAX system is used as a single ATM link, or is part of
a group of inter-connected ATM links that process OAM
maintenance cells only.
Has the characteristics of both an end point and a segment
point.
mediate ATM device that does not terminate the ATM con-
nection. It only generates AIS cells during a local failure.
Use this value to enable trunk conditioning. For more
information, see the Trunk Conditioning Application Note for
PacketStar
Note: The OAM loopback test is supported for end-to-
end connections only.
Any connecting point inside a segment flow.
This field displays the current status of the connection. The
value indicates whether the connection is passing traffic.
If the parameters are valid, the Connections window appears with the
new connection in the Listing page, and the Display Connection
window appears with tabs that contain details about the connection (see
Figure 8-27): Primary, Statistics, Backup, and Utilization.
If a parameter is invalid, a Connection Creation Failed message appears,
stating the reason for the failure.
The Primary page displays the information used to create the connection. See
Table 8-6 for field descriptions.
Creating ATM-to-ATM VPC PVC Connections
Description
PSAX Multiservice Media Gateways.
®
®
System
Release 7.0
8-45