Chapter 7 Provisioning Connections Using the Console Interface
Adding a Circuit Emulation-to-Circuit Emulation PVC Connection
Table 7-29. Field Descriptions for the Circuit Emulation-to-ATM VCC SPVC Statistics Window
Field Names
Received
Odometer
(display only)
Transmitted
Odometer
(display only)
Creating a VBR-to-
ATM Connection
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
7-116
Values
6.5000 e1
Total number of ATM cells received since odometer was
(default)
last reset.
6.5000 e1
Total number of ATM cells transmitted since odometer
(default)
was last reset.
Perform the steps in the following procedure to create an VBR-to-ATM SPVC
connection.
Steps to Create a VBR-to-ATM SPVC Connection
Begin
To add a VBR-to-ATM VCC SPVC connection, proceed as follows.
1 On the SPVC Connection Configuration Menu window, select VBR-to-
ATM VCC(w), and press Enter.
The VBR-to-ATM VCC SPVC Table window is displayed (see
Figure 7-48).
Figure 7-48. VBR-to-ATM VCC SPVC Table Window
Note:
At the time of initial installation, the VBR-to-ATM VCC SPVC
Table window is empty. After you have set up connections, this
window is displayed all the connections of this type in the system.
Description
Release 7.0
255-700-184