Physical Port Configuration - Lucent Technologies PacketStar PSAX Series User Manual

1-port channelized sts-1e, t1 format module

Hide thumbs Also See for PacketStar PSAX Series:

Table of Contents

Physical Port

Configuration

1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1

Chapter 4 Configuring Ports and Channels Using the AQueView

Provisioning Window (Displaying a Typical Setup)

Perform the steps in the following procedure to configure physical ports on

the 1-Port Channelized STS-1e, T1 Format module.

Configuring the Physical Ports

1 Do one of the following to open the Port and Channel Configuration

~ In the Front Panel, click the left button twice on the port to be

configured or displayed (see Figure 4-5).

~ In the Front Panel, double-click the right button on the port and a

menu is displayed. Click Configure in the menu that is displayed.

~ In the Device Tree, double-click the desired port symbol or identifier

with the left mouse button.

~ In the Device Tree, select a port, and click the right mouse button on

the Device Tree. After a menu is displayed, click Configure.

Using the Right-Click Menu