Table of Contents
Advertisement
Chapter 8 Provisioning Connections Using the AQueView
Creating ATM-to-ATM VPC PVC Connections
Adding Frame Relay-to-Frame Relay Connections
Creating a Frame
Relay-to-Frame Relay
Connection
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
8-94
The Out B or Decoded B column displays cells or bits transmitted from side A
to side B (also displayed on the Statistics page in the Cells Transmitted field
on the Interface B Statistics panel).
7 Select a time interval from the pull-down menu.
8 Average bits per second is displayed by default. If you want to display
utilization by average cells per second, click Average Cells/Sec.
9 Click Poll+ and the polling begins. Click Poll- to terminate polling.
10 To refresh this window, click Clear.
11 To close the Display Connection window, click Close.
12 To save this connection to the PSAX configuration database, click
Device > Save PSAX Configuration in the Provisioning Menu Bar.
!
CAUTION:
Click Device > Save PSAX Configuration to permanently save the
configuration.
Applied, but unsaved configuration data will not be lost unless the PSAX
system is restarted, or if power to the PSAX system is lost. Terminating the
AQueView EMS will not cause the applied values to be lost because the
configuration data is stored on the PSAX system, not in the AQueView EMS.
End
Perform the steps in the following procedure to create a frame relay-to-frame
relay connection.
Creating a Frame Relay-to-Frame Relay Connection
Begin
1 Click the Connections tab.
The Listing page appears.
2 Click the right mouse button and a menu appears. Click Create New.
The Create Connection window appears (see Figure 8-51).
®
System
Release 7.0
255-700-184
Advertisement
Table of Contents
