Configuring Pvc Connections - Lucent Technologies PacketStar PSAX Series User Manual

1-port channelized sts-1e, t1 format module

Hide thumbs Also See for PacketStar PSAX Series:

Table of Contents

Chapter 7 Provisioning Connections Using the Console Interface

Configuring PVC Connections

Connection Types by

Interface Type

Configuring PVC Connections

1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1

~ Variable bit rate (VBR)-to-ATM virtual channel connection (VCC) (w)

PVCs consist of connections between ports on the various PSAX I/O modules.

When setting up some types of connections, you can set up data traffic to

flow in several ways, depending on the type of connection as follows:

Data flows in two directions between the two connection points

(interface side A and interface side B).

Data flows in only one direction, from side A to side B, or from side B to

• Point-to-multipoint (not supported for the Channelized DS3 module)

Data flows in only one direction, from one point on side A to several

points on side B, or from one point on side B to several points on side A.

Before you can provision connections, you must select an interface type

value other than Unconfigured in the Interface Type field on the

Channelized DS3 Port and Channel Configuration window.

For a matrix of connection types by interface types, see the "Connection

Types by Interface Types Table" in the Reference Table appendix of this user

Accessing the Connection Configuration Menu

1 Log onto the PSAX system (see the appropriate PacketStar

Multiservice Media Gateway user guide for instructions).

The Console Interface Main Menu window (see Figure 7-1) is displayed.