Table of Contents
Advertisement
Chapter 6 Configuring the Interfaces Using the AQueView
Configuring the Circuit Emulation Interface Interface
Table 6-6. Field Descriptions for the ILMI Statistics Page
Field Name
Cold Starts Received
(display only)
PDUs Received
(display only)
PDUs Transmitted
(display only)
Time Elapsed
(display only)
Configuring the Circuit Emulation Interface Interface
Buttons
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
6-34
Number of times a Cold Start trap message was received.
Total number of packets received.
Total number of packets transmitted.
Time, in seconds, since last reset.
This section provides instructions for configuring an I/O module for the
Circuit Emulation interface.
Setting Up the Interface
Begin
When you select CircuitEmulation as the interface type in the Channel
Configuration page, the Circuit Emulation Interface Configuration window
appears (see ).
1 Select the values for the buttoms on this window from the following
table:
®
System
Description
Release 7.0
255-700-184
Advertisement
Table of Contents
