Setting The Values For Ports And Channels - Lucent Technologies PacketStar PSAX Series User Manual

1-port channelized sts-1e, t1 format module

Hide thumbs Also See for PacketStar PSAX Series:

Table of Contents

Setting the Values for Ports and Channels

1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1

Chapter 3 Configuring Ports and Channels Using the Console Interface

1-Port OC-3c Multimode and Single-Mode (Traffic Shaping and

AQueMan) modules

1-Port STM-1 Multimode and Single-Mode (Traffic Shaping and

AQueMan) modules

The following modules support line loop or local loop only if the standby is

preconfigured on a port-by-port basis:

1-Port OC-3c 1+1 APS Multimode and Single-Mode modules

1-Port STM-1 1+1 MSP Multimode and Single-Mode modules

1-Port OC-12c/STM-4c 1+1 APS/MSP Multimode and Single-Mode

This module has one physical port that is designated as Port 29 on the

console interface. This port is divided into 28 virtual ports. Each virtual port

can be divided (channelized) into 24 DS0 channels.

Configuring the Virtual Ports

1 On the Console Interface Main Menu window, select the Equipment

Configuration option and press Enter.

The Equipment Configuration window (Figure 3-2 on page 3-4) is