Table of Contents
Advertisement
Chapter 6 Configuring the Interfaces Using the AQueView
Configuring the ATM UNI and ILMI Interfaces
Viewing Registered
Addresses
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
6-32
Table 6-5. Field Values for the ATM UNI ILMI Configuration Window
Field Name
Timer T
Default: 5
Range: Varies
Timer S
Default: 1
Range: Varies
Retry K
Default: 4
Range: Varies
ILMI VPI
Default: 0
This value does
not change.
ILMI VCI
Default: 16
This value does
not change.
3 To apply the interface configuration values, click Apply.
4 To go back to the ATM UNI Interface Configuration window, click Close.
5 To activate the interface after you have applied the configuration values,
click Bring Into Service.
End
To set values for ILMI registered addresses, perform the steps in the following
procedure.
Viewing Registered User Addresses
Begin
1 Click Registered User Address Table on the ILMI Configuration page.
The ILMI Registered User Address Table window appears (see
Figure 6-13).
®
System
Values
Timer T in seconds. Used to poll when
link is operational.
The value in this field in displayed as a
32-bit integer, and any number may
appear.
Timer S in seconds. Used to poll when
link is not operational.
The value in this field in displayed as a
32-bit integer, and any number may
appear.
Retry K in seconds. Indicates the num-
ber of timeouts before the link becomes
non-operational.
The value in this field in displayed as a
32-bit integer, and any number may
appear.
VPI for the ILMI protocol channel in
which VPI will run.
VCI for the ILMI protocol channel in
which VCI will run.
Description
Release 7.0
255-700-184
Advertisement
Table of Contents
