Table of Contents
Advertisement
Table 7-8. Field Values for the Circuit Emulation-to-ATM VCC PVC Statistics
Field Names
Time Since
Reset
AIS Rx/Tx
0/0 (default)
RDI
0/0 (default)
Cells Received
6.5000 e1
(default)
Cells Transmit-
6.5000 e1
ted
(default)
Received
6.5000 e1
Odometer
(default)
Transmitted
6.5000 e1
Odometer
(default)
Backup Connection
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 7 Provisioning Connections Using the Console Interface
Values
Total time elapsed for OAM statistics collection since the last
time the Reset Odometers command was used.
Note:
The Reset Odometers command on the statistics
window resets only the odometer fields and the corresponding
clock. Other counters increment for the life of the circuit.
Number of OAM alarm indication signal cells received and
transmitted.
Number of OAM remote defect indication cells received and
transmitted.
The total number of received OAM cells going into interface
side A during the amount of time shown in the Time Elapsed
field (i.e., since the circuit was created).
The total number of transmitted OAM cells going out of inter-
face side A during the amount of time shown in Time Elapsed
field (i.e., since the circuit was created.)
Total number of ATM cells received since odometer was last
reset.
Total number of ATM cells transmitted since odometer was last
reset.
End
Steps to View/Add a Circuit Emulation-to-ATM VCC Backup PVC
Connecion
Begin
1 From the Circuit Emulation -to-ATM VCC PVC Connection window,
select the Add/View Backup PVC command and press Enter.
The Circuit Emulation -to-ATM VCC Backup PVC Connection window
is displayed (see Figure 7-14).
Adding a Circuit Emulation-to-ATM VCC PVC Connection
Description
Release 7.0
7-37
Advertisement
Table of Contents
