Table of Contents
Advertisement
Configuring the ATM Private Network-Network Interface
(PNNI 1.0)
Setting Up the Interface
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 6 Configuring the Interfaces Using the AQueView
Configuring the ATM Private Network-Network Interface (PNNI 1.0)
Table 6-11. Field Values for the HDLC Passthrough Interface Statistics Page
Field Name
Cells Encoded(dis-
Incoming cells from the outside media to the I/O
play only)
port.
Cells Decoded
Outgoing cells from the I/O port to the outside
(display only)
media.
Frames Encoded
The number of encoded frames transmitted.
(display only)
Frames Decoded
The number of encoded frames received.
(display only)
Frames Mis-
Number of mismatched cells received into interface
side A during the amount of time shown in Time
matched
Elapsed field.
(display only)
Errored Frames
Number of errored frames received so far.
(display only)
AAL5 Errors
Number of (ATM adaptation layer 5) errors going
(display only)
into interface side A during the amount of time
shown in Time Elapsed field.
Time Elapsed
Time, in hours, minutes and seconds, since last reset.
(display only)
The format is HH:MM:SS.
End
This section provides instructions for configuring an I/O module for the ATM
private network-network interface (PNNI)1.0. The following I/O modules
have ATM PNNI 1.0 interface capability:
Before you can select the value as the interface type, you must first configure
the PNNI node (see Chapter 6 in the appropriate AQueView
Management System User Guide).
When you select AtmPnni1_0 as the interface type in the Channel
Configuration page, the ATM PNNI Interface Configuration window appears
(see Figure 6-27).
Description
®
Element
®
System
Release 7.0
6-59
Advertisement
Table of Contents
