Table of Contents
Advertisement
Chapter 8 Provisioning Connections Using the AQueView
Creating ATM-to-ATM VPC PVC Connections
Table 8-21. Field Values for the VBR-to-ATM _VCC Connection Window
Field Names
OAM Status
Default: Unsupp
End-Pt
End-Seg-Pt
Connection Sta-
Default: Inactive,
tus
Active
(display only)
Connection Fail-
None (default)
ure Cause A
Physical
(display only)
Connection Fail-
None (default)
ure Cause B
Physical
(display only)
Primary Page
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
8-122
Values
OAM is not in use.
The PSAX system is used as a termination point for ATM
traffic, and will process AIS/RDI cells.
Note:
end connections only.
Has the characteristics of both an end point and a segment
point.
This field displays the current status of the connection.
The value indicates whether the connection is passing
traffic.
General connection failure cause.
General connection failure cause.
If the parameters are valid, the Connections window appears with the
new connection in the Listing page, and the Display Connection
window appears with tabs that contain details about the connection (see
Figure 8-64): Primary, Statistics, Backup, and Utilization.
If a parameter is invalid, a Connection Creation Failed message appears,
stating the reason for the failure.
The Primary page displays the information used to create the connection. See
Table 8-21 for field descriptions.
®
System
Description
The OAM loopback test is supported for end-to-
Release 7.0
255-700-184
Advertisement
Table of Contents
