Table of Contents
Advertisement
Chapter 6 Configuring the Interfaces Using the AQueView
Configuring the PRI ISDN Network/User Interface
Copying an Interface Configuration
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
6-82
Table 6-16. Field Values for the PRI ISDN Network/User Configuration Window
Field Name
L2 State
Tei-unassigned,
tei-assigned,
(display only)
waiting-
establishment,
awaiting-
release,
multiple-frame-
established,
timer-recovery
T200 (secs)
Default: 1.0
Range: 0.1–10.0
T203 (secs)
Default: 10
Range: 1–60
N200 (secs)
Default: 3
Range: 1–5
N201 (octets)
Default: 260
Range: 1–300
Window Size (K
Default: 7
frames)
Range: 1–127
2 Click Apply.
3 To activate the interface after you have applied the configuration values,
click Bring Selected Into Service.
The value InService is displayed in the B Channel Status panel.
End
The Copy button on each Interface Configuration window enables you to
copy an interface configuration to a range of channels. To copy an interface
configuration to a range of channels, perform the steps in the following
procedure from the appropriate Interface Configuration window.
Copying an Interface Configuration to Multiple Channels
Begin
1 In the Interface Configuration window, click Copy.
The Copy Interface Configuration window appears with the slot, port,
and channel of the interface you selected in the Start At: and Stop At:
panels (see figure below).
®
System
Values
The current state of the ISDN Layer 2
protocol.
The value of the L2 T200 timer in 1/10
seconds.
The value of the L2 T203 timer in sec-
onds.
The maximum number of retransmis-
sions before the LAP-D link is declared
to be not operational.
The maximum number of octets in an
information field.
The maximum number of outstanding
I frames.
Description
Release 7.0
255-700-184
Advertisement
Table of Contents
