Table of Contents
Advertisement
Configuring the ATM PNNI 1.0 Interface
Optimizing SVC Call Performance
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 5 Configuring the Interfaces Using the Console Interface
Table 5-1. Field Values for the ATM IISP Interface Configuration Window
Field Name
[Ingress Avail
Default: 0
BW] (cps)
(display only)
[Egress Avail
Default: 0
BW] (cps)
(display only)
2 To apply the interface configuration values, select the Apply Interface
Configuration command and press Enter.
3 To activate the interface after you have applied the configuration values,
select the Bring Interface Into Service command and press Enter.
Note:
The interface must have in-service status so that the PVCs and
SVCs you will set up to use this interface will work.
End
The service-specific connection-oriented protocol (SSCOP) field is set on
these interface configuration windows: ATM IISP network or IISP user, ATM
UNI 3.0 or UNI 3.1, or ATM PNNI 1.0.
Note:
These settings are suggested for connecting to a Multiservice
Media Gateway from a remote site only. The Multiservice Media
Gateway configures these settings internally in its own ATM
switch.
Configuring the ATM PNNI 1.0 Interface
Values
This represents the total ingress and
egress bandwidth available for virtual
interfaces. 0 will change to 353207 after
Apply has been selected. As each new
virtual interface is created, the amount
of available bandwidth as indicated in
this field will decrease. The value of this
field ranges from 0–353207 after being
brought in service.
This represents the total ingress and
egress bandwidth available for virtual
interfaces. 0 will change to 353207 after
Apply has been selected. As each new
virtual interface is created, the amount
of available bandwidth as indicated in
this field will decrease. The value of this
field ranges from 0–353207 after being
brought in service.
Description
Release 7.0
5-7
Advertisement
Table of Contents
