Adding An Aal2 Trunk Entry - Lucent Technologies PacketStar PSAX Series User Manual

Adding an AAL2 Trunk Entry

®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 8 Provisioning Connections Using the AQueView
a. Assign the slot, port, and channel for the DSP connection you want
to multiplex.
b. In the same window, select Aal2Std in the SAR Type field. Selecting
this value enables you to select connection identifiers (Cids) 8–255
in the AAL2 Cid field on the upper right panel. Assign one CID per
connection.
To create a non-multiplexed AAL2 or AAL-1 connection, you need a
configured circuit emulation interface. To create a standard AAL2
connection, you need a configured circuit emulation interface and an AAL2
trunk.
Perform the steps in the following procedure to add an AAL2 trunk.
Steps to Configure an AAL2 Trunk Connection
Begin
1 Click the AAL2 Trunk tab in the Connections tab.
The AAL2 Trunk page appears, displaying the AAL2 Trunk
Configuration Table (see Figure 8-11).
If the AAL2 Trunk Configuration Table is empty before you perform
Step 2, the AAL2 Trunk Config Entry window will appear with the
default values.
If you select an existing AAL2 trunk entry before performing Step 2, the
AAL2 Trunk Config Entry window will appear as a template, containing
the values of the original AAL2 trunk entry.
Figure 8-11. AAL2 Trunk Page (Displaying Menu)
2 Right-click the mouse and a menu appears. Select Create.
The AAL2 Trunk Config Entry window appears (see Figure 8-12).
®
System
AAL2 Trunk Configuration
Release 7.0
8-15