Creating A Vbr Or Cbr Routing Table Entry - Lucent Technologies PacketStar PSAX Series User Manual

1-port channelized sts-1e, t1 format module

Hide thumbs Also See for PacketStar PSAX Series:

Table of Contents

Chapter 8 Provisioning Connections Using the AQueView

Adding Switched Virtual Connections

Creating a VBR or

CBR Routing Table

Signaling is

1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1

Adding a VBR or CBR Routing Data

Before you can set up IISP routing, you must configure the port from which

you want to route traffic with the ATM UNI or ATM IISP interface. Use the

following procedure to add a VBR or CBR routing entry.

1 From the Front Panel, open the Port and Channel Configuration

window for the port you want to route.

2 Select an ATM UNI or ATM IISP interface type.

3 Click Apply to Selected.

4 In the Channel Configuration window, double-click the channel that

you want to configure.

5 On the Interface Configuration window, select Enabled in the ATM

Signaling field (see Figure 8-81).

Figure 8-81. ATM UNI 3.1 Interface Configuration Page

(Displaying ATM Signaling as Enabled)

6 In the Interface Configuration window, click Apply > Bring Into Service

7 Click the IISP Routing tab in the Provisioning window.