Table of Contents
Advertisement
Configuring the Integrated Link Management Interface (ILMI)
Setting Up the
Interface
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
255-700-184
Chapter 6 Configuring the Interfaces Using the AQueView
Configuring the ATM Private Network-Network Interface (PNNI 1.0)
The Total Bandwidth (bps) panel displays the total width of the channel in
bits per second.
Note:
The PSAX EMS polls the PSAX device and displays this data, but
does not store it. If the you have installed the PSAX EMS on a
network management system (NMS) framework, such as like HP
OpenView, then you already have this functionlity through the
NMS software. For example, HP OpenView NNM allows you
collect and store data.
8 Click Poll- and the polling terminates.
End
The integrated link management interface (ILMI) contains a management
information base (MIB) that provides status and communication information
to the PSAX system and other switching devices configured for ATM UNI.
ILMI supports bi-directional exchange of ATM interface parameters between
two connected ATM Interface Management Entities (IMEs).
ILMI provides status information and statistics using Simple Network
Management Protocol (SNMP) and a MIB to provide any ATM device with
status and configuration information concerning the virtual path connections
(VPCs), virtual channel connections (VCCs), registered ATM network
prefixes, registered ATM addresses, and registered services and capabilities
available at its ATM interfaces. It also determines the operational status of the
logical port. ILMI is supported for all ATM UNI 3.0 and ATM UNI 3.1
interfaces.
To set values for ILMI configuration, perform the steps in the following
procedure.
Setting the Values for the ILMI Configuration Window
Begin
1 Click the ILMI Configuration tab.
The ILMI Configuration page appears (see Figure 6-32).
®
System
Release 7.0
6-73
Advertisement
Table of Contents
