Table of Contents
Advertisement
Chapter 7 Provisioning Connections Using the Console Interface
Adding a Circuit Emulation-to-Circuit Emulation PVC Connection
Table 7-26. ATM-to-ATM VCC SPVC Statistics Window
Field Name
Transmitted
Odometer
Time Elapsed
Time Since Reset Time elapsed since the last time the Reset Odometers com-
Adding NSAP
Addresses
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
7-104
Number of valid cells transmitted since this counter was reset.
Note: This counter serves as an odometer while the cells
Tx/Rx counters track usage for the life of the circuit.
Time, in hours, minutes, and seconds, since last reset.
mand was used.
End
To add NSAP addresses, perform the steps in the following procedure.
Adding NSAP Addresses to the SPVC Address Table
Begin
1 On the ATM-to-ATM VCC SPVC Table window select the Go Back to
Connection Table command and press Enter (or press Ctrl+B).
The SPVC Connection Configuration Menu is displayed (see
Figure 7-39).
2 Select the Configure Local Address command and press Enter.
The SPVC Address Table window is displayed (see Figure 7-43).
Figure 7-43. SPVC Address Table Window
Description
Release 7.0
255-700-184
Advertisement
Table of Contents
