Adding Nsap Addresses - Lucent Technologies PacketStar PSAX Series User Manual

1-port channelized sts-1e, t1 format module

Hide thumbs Also See for PacketStar PSAX Series:

Table of Contents

1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1

Chapter 6 Configuring the Interfaces Using the AQueView

Step 2 through Step 4 are optional. If you do not want to add or

retrieve an NSAP address, skip to Step 5.

If an NSAP address exists in the NSAP address database for a given device,

the local NSAP address automatically retrieved and displayed on the Interface

Configuration window. You may choose to add an NSAP address for a slot,

port, and channel in the NSAP address database and retrieve it by clicking

Retrieve from NSAP database.

2 To add or retrieve an NSAP address, enter a valid NSAP address in the

Local NSAP Address (Hex) field and click Retrieve from NSAP

If the value entered in the Local NSAP Address (Hex) field is valid, the

field becomes ghosted. The Select NSAP window appears (see the

following figure).

Figure 6-14. Select NSAP Window

The buttons in this window have the following functions:

Enters the NSAP address for a device that is selected on the

Select Remote NSAP window into the Remote NSAP

Address field of the Interface Configuration window.

Adds a new slot, port, channel, NSAP address mapping

entry for the specified device.

Stores any modifications to the NSAP address database.

Closes this window.

Configuring the Circuit Emulation Interface Interface