Table of Contents
Advertisement
Chapter 5 Configuring the Interfaces Using the Console Interface
Configuring the ATM UNI 3.0/3.1 Interface
Displaying Registered
Addresses
Commands
Viewing ILMI
Statistics
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
5-32
4 To activate the interface after you have applied the configuration values,
select the Bring Interface Into Service command and press Enter.
5 Select the ILMI Registered User Address Table command and press
Enter.
The ILMI Registered User Address Table window is displayed (see
Figure 5-9).
Figure 5-9.
ILMI Registered User Address Table Window
The commands in this window have the following functions:
Command
• Find.. Atm Addr: . .
• Go Back to Interface
Screen →
The NSAP Address (Hex) column displays the user's registered
addresses. The Org Scope column displays the scope of the registered
addresses. If the scope is not set by the user, it will default to global (a
value of 15).
6 To go back to the ATM UNI Interface Configuration window, select the
Go Back to Interface Screen command and press Enter.
To view ILMI configuration statistics, do the following:
7 Select the ILMI Statistics command and press Enter.
The ILMI Statistics window is displayed (see Figure 5-10).
Function
• Finds the user's ATM address.
• Redisplays the ATM UNI Interface Configura-
tion window.
Release 7.0
255-700-184
Advertisement
Table of Contents
