Creating An Atm-To-Atm Vcc Spvc Connection - Lucent Technologies PacketStar PSAX Series User Manual

1-port channelized sts-1e, t1 format module

Hide thumbs Also See for PacketStar PSAX Series:

Table of Contents

Creating an ATM-to-

ATM VCC SPVC

1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1

Chapter 7 Provisioning Connections Using the Console Interface

Adding a Circuit Emulation-to-Circuit Emulation PVC Connection

The commands on this window have the following functions:

• Go Back to Connection

2 Select the Add an Entry field, and press Enter.

a. Type a network service access point (NSAP) address in hexadecimal

format up to 20 bytes (160 bits) long (10 groups of 4 characters

each), and press the Tab key.

b. In the Num Bits field, type a value from 1–152 for the NSAP address

mask, and press the Tab key.

c. In the Slot Port Chnl field, type the slot, port, and channel values

for the ATM-cell-bearing I/O module that has a configured ATM IISP

(User or Network) interface.

d. Press Enter to add the entry to the table.

3 Repeat step 2 as many times as needed to add entries to the table.

4 To permanently save these table entries, press Ctrl+G to return to the

Console Interface Main Menu window.

5 Select Save Configuration, and press Enter to store the values to the

Multiservice Media Gateway system database.

Perform the steps in the following procedure to create an ATM-to-ATM VCC

SPVC connection.

Finds the routing entry with the specified

NSAP address.

Redisplays the Connection Configuration