Table of Contents
Advertisement
Chapter 6 Configuring the Interfaces Using the AQueView
Configuring the Circuit Emulation Interface Interface
Changing Field Values Without Deleting the Interface
®
1-Port Channelized STS-1e, T1 Format Module User Guide, Issue 1
PacketStar
6-52
Table 6-10. Field Descriptions for the Frame Relay LMI Statistics Page
Field Name
Receive Status
Number of status messages received.
(display only)
Enquiries
Number of status enquiry messages received.
Received
(display only)
Async Enquiries
Number of asynchronous status messages received.
Received
(display only)
Transmit Status
Number of status messages transmitted.
(display only)
Enquiries Trans-
Number of status enquiry messages transmitted.
mitted
(display only)
Async Enquiries
Number of asynchronous status messages transmitted.
Transmitted
(display only)
T392 Expirations
Polling verification timer expires.
(display only)
Packets Discarded
Number of LMI messages discarded due to invalid
(display only)
length, receive sequence numbers, or other error.
Link Resets
Number of times interface operational status was in ser-
(display only)
vice after the system startup.
Time Elapsed
Time elapsed since last reset.
(display only)
The following values can be changed without deleting the interface after it
has been brought into service:
• DLCMI State
• LMI Protocol
• LMI Asynchronous • T392
• N391
• N392
You must take the interface out of service before changing these field values.
To change any other fields in the Frame Relay Interface Configuration
window, you must delete the interface. Follow the instructions in "Changing
Interface Values" to delete the interfaces.
®
System
Description
• N393
• T391
• NT3
Release 7.0
255-700-184
Advertisement
Table of Contents
