Installation - Porsche 996 TT Repair Manual

5. Pull off the connecting hoses between the charge air coolers and the pressure pipe. To do this,
unclip the locking clips with a screwdriver. Then return the locking clips to installation position.
Additionally undo a fastening screw on the right−hand pressure pipe side.
6. Undo pressure pipe −middle− by removing the spring clip −5− , hose clamp −3− , hexagon−head
bolts −1 & 2− and electrical plug −4− . Pull off vacuum hose to the control valve.
7. Pull off electrical plug. Undo the fastening screws and remove the throttle
body.
8. Pull off plug, unscrew oil temperature sensor by using a straight ring wrench, A/f 22.
top of page

Installation

1. Fasten oil temperature sensor with new sealing ring.
2. Check throttle sealing ring and replace it if necessary. Fasten throttle body. Push on electrical plug.
Removal
einordnung
503